Make it yourself
Here's another canopy look that is easy to duplicate.
You'll need to purchase and install a section of pipe, doweling, or curtain rod securely to the wall behind the bed. Place it in the range of six to eighteen inches below the ceiling. Attach to a wall stud whenever possible, however it should be centered over the bed. Also install two tiebacks on either side of the bed, about 30" or more off the floor.
|
Next, measure for the length of the fabric using a piece of rope or string. Measure from the floor on one side of the bed, up and over the tiebacks and the center pipe, then back down to the floor. Make sure the string makes a graceful swag up to the top (as your fabric will) rather than being perfectly straight. To this measurement add about 1/2 yard extra fabric to allow for hems and the rod pocket.
An unlined fabric (like the one shown in the top photo) looks best when fabric has two good sides. Otherwise sew a lining into your panel before stitching the rod pocket. In the alternative, the fabric can be "self lined" by folding it in half lengthwise before sewing in the top rod pocket.
Dress up the look with contrasting linings, fringes, welting, tie-backs, or other interesting details.
An Unlined Swagged Canopy Treatment
One long length of fabric is all it will take for this treatment. Sew a simple rod pocket at the top and you're done.
Lined Canopy with Trims
A similar style swagged canopy shows the effect of using a lined panel that's been dressed up with a gathered border in a contrasting fabric. This is a great way to bring in more detail and color to coordinate the hangings with the bed pillows and comforter.